Server+ (2005) SK0-002 Test
Question: 1The performance of a RAID 5 dual processor database server is degrading over time. Symptomsinclude excessive disk access, high memory utilization, and slow responses to databasesearches. Which action should be taken to reduce the server's bottleneck
A. add more RAMB. implement RAID 1C. upgrade the CPUsD. add additional CPUsE. increase the swap file size
Answer: A
Question: 2A consulting firm is hired by Company.com in an earthquake-prone area to review their disasterplan. Review of the disaster recovery plan reveals the following:
1. Offsite backup storage is in a locked fireproof safe, with restricted key access. All tape backupsare stored in this safe.2. There is a reciprocal agreement with a sister company located two blocks fromCompany.com's location to store each other's backup safes. Plans are in place to allow 24-houraccess to backups.3. The selected hot site is 100 miles from the normal business site.4. AGFS (Grandfather-Father-Son) tape rotation plan is in use.
What changes should be made to the plan?
A. make no changesB. change tape rotation systemsC. send tape backups to a more remote facilityD. move the hot site closer to the normal business site.
Answer: C
Question: 3A new switch has recently been installed on the Network. The SNMP (Simple NetworkManagement Protocol) manager has not seen any information from the device. Which are twopossible causes of this problem? Select two.
A. The MIB (Management Information Base) needs to be installed.B. SNMP (Simple Network Management Protocol) community needs to be configuredC. The SNMP (Simple Network Management) manger needs to be configured.D. Firmware on the device needs to be updated.
Answer: A, B
Question: 4A biometric access device is used with which security method?
A. qualificationB. authorizationC. accountabilityD. authentication
Answer: D
Page 1 of 151Question: 5Which of the following is the maximum cable length for Ultra 160?
A. 1.5 metersB. 3 metersC. 6 metersD. 12 metersE. 25 meters
Answer: D
Explanation:
Question: 6A server was recently installed with all necessary hardware and software. Before placing theserver into service, a(n)_________should be created.
A. application backupB. System Monitor logC. performance baselineD. Performance Monitor log
Answer: C
Question: 7Additional memory is being added on a server. Which two precautions should be taken to ensurethe memory is NOT damaged by ESD (electrostatic discharge) during the installation process?Select two.
A. wear an antistatic wrist strapB. wear shoes with rubber solesC. ensure the server is connected to a UPS (Uninterruptible Power Supply)D. ensure the server is grounded before commencingE. ensure the server is connected to a surge protector
Answer: A, D
Question: 8The RAM in a server needs to be upgraded. The requirement is to use memory that is capable ofoperating at 1200 MHz and can transfer data up to 10.7 GB/sec. Which type of RAM should beinstalled on the server?
A. DRAMB. RDRAMC. DDR SDRAMD. BDDR SDRAM
Page 2 of 151Answer: B
Explanation:The RDRAM device is a general purpose high performance memory device suitable for use inabroad range of applications including computer memory, graphics, video, and any otherapplication where high bandwidth and low latency are required. The 256/288 Mb RDRAMdevices are extremely high speed CMOS DRAMs organized as 16M words by 16 or18 bits. Theuse of RambusSignaling Level (RSL) technologypermits 600MHz to 1200 MHz transfer rateswhileusing conventional system and board designtechnologies. The 256/288 Mb RDRAM devices areoffered in a CSP horizontalpackage suitable for desktop as well aslowprofile add-incard andmobile applications.
Question: 9An external Ultra2 RAID storage unit is to be installed during the setup of a new site. Which threeactions will likely cause a problem when the external RAID storage unit is installed? Select three.
A. using passive termination on the enclosureB. using a SCSI cable between one and five meters in lengthC. connecting the subsystem to the server while it is powered upD. powering off the RAID subsystem when the server is turned on
Answer: A, C, D
Question: 10A series of replacement servers are installed on a network. SNMP monitoring server hadpreviously been able to retrieve the statistics from the servers, but is not able to retrieve statisticsfrom the new servers. Which statement is true?
A. The DMI (Desktop Management interface) agents need to be loaded on the servers.B. The latest service packs are needed fro the SNMP monitoring server.C. An upgrade to SNMP Version 3.0 on the SNMP monitoring server is needed.D. SNMP community strings need to match between the servers and the SNMP monitoring server.
Answer: D
Question: 11A server has twelve 72 GB drives configured in a RAID 5 array, with one drive as a hot spare. Itexperiences a failure of one of the drives in the array. Which action should be taken?
A. replace the failed drive and rebuild the array.B. replace the failed drive and restore parity data from backup.C. swap the failed drive with the hot spare and rebuild the arrayD. ensure the array has completed rebuilding, then replace the failed drive
Answer: D
Question: 12A UPS is being selected for a remote office. The correct size UPS needs to be determined.Which formula should be used to determine the load requirements?
A. VA = Volts x AmperesB. KVA = Volts x AmperesC. Watts= Current x Voltage
Page 3 of 151D. VA = KW x 1000 x Amperes
Answer: A
Question: 13A server recently had a RAID controller replaced under warranty by the manufacturer. Since therepair, the system seems to be generating several write errors, and sometimes does not boot intothe operating system. Which of the following is the MOST effective solution to apply FIRST?
A. replace the RAID controller, as it is damagedB. replace the system board, as it is damagedC. replace the device drivers, as they are incorrect.D. replace the RAID configuration, as it is incorrect.
Answer: C
Question: 14An engineer installs an SMP (Symmetrical Multi-Processing)-compliant network operating systemon a dual-processor server. The BIOS detects two processors, but only one processor isrecognized by the network operating system. Which action should the engineer take to enablethe SECOND processor?
A. update the BIOS to the current versionB. apply the latest network operating system patchesC. update the stepping level on the second processorD. configure the network operating system kernel for SMP (Symmetrical Multi-Processing) support
Answer: D
Question: 15Users report that the intranet database is slow to respond during peak use times. The databaseserver is on a small 150-user network and is configured with dual processors, 512 MB RAM, anda hardware-controlled RAID 5arraywith three drives. The server also provides DNS and DHCPservices for the intranet. Which three are ways to improve server performance? Select three.
A. set processor affinityB. add a hard drive to the RAID 5 arrayC. move the DNS and DHCP services to another serverD. move the page file to another partition on the RAID 5 array
Answer: A, B, C
Question: 16During a new server installation, which of the following is the MOST common setup problem?
A. incompatible memoryB. access to power and network connectionsC. flashing the BIOSD. operating system HCL (Hardware Compatibility List)
Answer: D
Question: 17Which two can be used to connect Fibre Channel devices? Select two.
Page 4 of 151A. fibre hubB. loop switchC. GBIC (Gigabit Interface Converter) moduleD. Layer 3 switch
Answer: A, B
Question: 18Which two statements are true about software-based RAID? Select two.
A. CPU load is increased when using software-based RAID.B. Intervention is not required to recover fully from a drive failure.C. Hot-plug and hot-spare features are available with software-based RAID.D. Hard disk make and model do not have to be the same when using with software-based RAID.
Answer: A, D
Question: 19Company.com, a small print service company, is backing up mission critical data and wants toimplement a disaster recovery plan. The network administrator is tasked with developing thedisaster recovery plan. Which step should be taken FIRST when developing the plan?
A. practice the disaster recovery driftsB. create a step-by-step restoration planC. determine the enterprise configurationD. explore disaster prevention techniques
Answer: C
Question: 20Which of the following can be used to collect trends and performance data?
A. SNMP (Simple Network Management Protocol) TrapsB. MIB (Management Information Base) browsingC. DMI (Desktop Management Interface) requestingD. regular SNMP (Simple Network Management Protocol) polling
Answer: D
Question: 21Which two should be included in server baseline documentation? Select two.
A. disaster recovery planB. disk performance statisticsC. server response time studyD. warranty status of the serverE. emergency technical support numbers
Answer: B, C
Question: 22A system administrator wants to remotely administer a server using a Web browser-basedapplication so he can administer remotely from any operating system. He wants to ensure that
Page 5 of 151
Original Resource :
Visit SK0-002 Link : SK0-002 Download PDF Link : SK0-002
No comments:
Post a Comment